The float controls an on off switch for the pump.
Tethered float switch adjustment.
To order a pump for your diy grey water project email sales greywaterdiy co za south africa or click here to order from amazon.
The pump is then idle until the water level rises again.
Test with bucket of water.
Step by step disconnect from power.
When the float rises to a pre set height the pump will be switched on.
Make sure the pump operates at the desired levels.
Adjust float up or down.
The pump will continue to operate until the float drops low enough to disengage the switch.
Anytime you are working on your sump pump it should be disconnected from the power.
Efore tightening adjust tether length.
Make any necessary adjustments at this time.
The float switch through at least two complete cycles.
Tether length.
Pump sold separately.
Next manually or electronically adjust the float switch up or down based on the water level in.